Can PIN 7 to be used as the signal modulation terminal to modulate the laser beam output? – DaviLaser

No. It cannot. PIN 7 is the control enable terminal of the laser tube. Too high switching frequency will cause laser failure. The switching frequency of signal for PIN 7 should be < 200Hz.

FAQS

Can PIN 7 to be used as the signal modulation terminal to modulate the laser beam output?

May 29, 2025

No. It cannot. PIN 7 is the control enable terminal of the laser tube. Too high switching frequency will cause laser failure. The switching frequency of signal for PIN 7 should be < 200Hz.

More News

2023 Munich Shanghai Optoelectronics exhibition DAVI Laser with a full range of products

DAVI Laser will participate in the 2025 Munich Shanghai Photovoltaic Exhibition

DAVI Laser shines at the Munich Optoelectronic Laser Technology Exhibition in Germany

Featured Articles

Laser tube need a certain pre-ionization time when it starts working, is it possible to speed up the pre-ionization time by intentionally sending a modulating signal?

What is the reason that the laser tube cannot start up normally after it has been unused for more than one week? What should be done in this case?

What should be paid attention during the storage and transport for the laser tubes?

Other precautions

If the laser output window mirror is polluted, how to deal with it? And whether can wipe it with cotton swabs?